Apogee ensemble Betriebsanweisung PDF herunterladen (Seite 29)

APOGEE ELECTRONICS

Ensemble – User’s Guide

Declaration of Conformity—FCC

Apogee Ensemble

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference

(2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful inteference in a residential

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. If this equipment does cause

harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following measures:

1. Re–orient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a different circuit from that to which the receiver is connected.

4. Consult the dealer or an experienced radio/TV technician for help.

NOTE: The use of non–shielded cable with this equipment is prohibited.

CAUTION: Changes or modications not expressly approved by the manufacturer responsible for compliance could void

the user’s authority to operate the equipment.

Apogee Electronics Corporation, 1715 Berkeley St, Santa Monica, CA 90404.

Betty Bennett, CEO.

Industry Canada Notice

This Class B digital apparatus meets all requirements of the Canadian Interference–Causing Equipment Regulations. Cet

appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matérial brouilleur du Canada.

Declaration of Conformity – CE

Apogee Electronics Corporation hereby declares that the product, the Ensemble, to which this declaration relates, is in

material conformity with the following standards or other normative documents:

• EN50081–1/EN55022; 1995

• EN50082–1/IEC 801–2, 3, 4; 1992

following the provisions of:

• 73/23/EEC – Low Voltage Directive

• 89/336/EEC – EMC Directive

Declaration of Conformity – Japan

Apogee Electronics Corporation hereby declares that the Ensemble, to which this declaration relates, is in material confor-

mity with the VCCI Class A standard.

Declaration of Conformity – Australia

Apogee Electronics Corporation hereby declares that the Ensemble is in material conformity with AN/NZS standard

requirements.

Declarations of Conformity

1 2 ... 24 25 26 27 28 29 30 31 32

Keine Kommentare

Apogee ensemble Betriebsanweisung Seite 29